Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 14 — Engine Stalls after Decelerating (Cont'd)

l

mactive test gw

[]

PERFORM POWER BALANCE TEST.

No Go to

* & * POWER BALANCE * * &

Vv MONITO

1. Perform “POWER BALANCE”

712rpm in “ACTIVE TEST” mode.

CAS-RPM (REF)

AIR FLOW MTR

1.02V 37%

2. Is there any cylinder which does not produce a momen- tary engine speed drop? TEST OR START When disconnecting each injec- SEF729K tor harness connector one ata time, is there any cylinder which ila does not produce a momentary DISCONNECT engine speed drop? Yes Vv No

AAC VALVE

Check injector(s) and cir-

CHECK INJECTOR.

1. Remove distributor assembly from cuit(s). engine. (Crank angle sensor harness ws son oN Ah Fuel injector connector connector should remain connected.) . Disconnect ignition coil harness con- SEF738K nector.

3. Turn ignition switch ON. (Do not start engine.)

4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes . N.G.

> Check ignition coil, power transistor unit and cir-

CHECK IGNITION SPARK.

1. Disconnect ignition wire from rocker cuits. (See page EF & cover. EC-107.) . Connect a known good spark plug to SEF837K the ignition wire. . Place end of spark plug against a Ignition wire suitable ground and crank engine. . Check for spark. | OK.

(Go to on next page.) 4 Spark plug —_ S | .S SEF282G

EF & EC-81

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.