REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
REAR AXLE — Drive Shaft
REAR AXLE — Drive Shaft
Inspection (Cont'd)
JOINT ASSEMBLY
@ Check spider assembly for bearing, roller and washer damage. Replace spider assembly if necessary. @ Check housing for any damage. Replace housing set and spider assembly, if necessary.
@ When replacing only spider assembly, select a new spider assembly from among those listed in table below. Ensure the number stamped on sliding joint is the same as that stamped on new part. Housing alone cannot be replaced. It must be replaced together with spider assembly.
| Stamped number | Part No. |
|---|---|
| 00 | 39720 10V10 |
| 01 | 39720 10V11 |
| 02 | 39720 10V12 |
SRA121A
Assembly e After drive shaft has been assembled, make sure it moves smoothly over its entire range without binding. @ Use Nissan Genuine Grease or equivalent after every overhaul.
FINAL DRIVE SIDE
1. Install new small boot band, boot and slide joint housing to drive shaft. Cover drive shaft serration with tape to prevent damage to ij boot during installation. Tape /( SFA800
RA-16
Parts & tools for this job For Nissan 240SX
- PARTRear wheel bearingSearch: Nissan 240SX rear wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Nissan 240SX cv boot kit
As an Amazon Associate we earn from qualifying purchases.