Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

1992_240sx: diagram

TROUBLE DIAGNOSES

Consult (Cont'd)

FUNCTION TEST ITEMCONDITIONJUDGEMENTCHECK ITEM (REMEDY)
ITEMCONDITION e After warming up, idle theJUDGEMENTCHECK ITEM (REMEDY)
engine.
e Injector operation of eache Injector circuit (Injector,
cylinder is stopped oneharness or connector)
POWER BALANCEafter another, and resultant change in engine rotation is examined toDifference in engine rpm is greater than 25 rpm before and after cutting off the injector of each cylinder.e Ignition circuit (Spark plug, power transistor, ignition coil, harness or
rotation is examined to evaluate combustion ofinjector of each cylinder.ignition coil, harness or connector)
each cylinder. (This ise Compression
only displayed for modelse Valve timing
where a sequential
injection system is used.)
e After warming up, idle thee Harness and connector
AAC VALVE SYSTEMengine. e@ AAC valve system is tested by detecting change in engine rpm when AAC valve opening is changedDifference in engine rpm is greater than 150 rpm between when valve opening is at 80% (102 steps) and at 20% (25 steps).e AAC valve e Air passage restriction between air inlet and AAC valve @ IAS (Idle adjusting screw)
to 0%, 20% and 80%.adjustment

EF & EC-54

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.