Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BODY - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BODY - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BODY - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BODY

FRONT DISC BRAKE (CL22VB, CL25VA) — Caliper

Inspection

CYLINDER BODY

@ Check inside surface of cylinder for scoring, rust, wear, damage or foreign materials. Replace if any such condition exists. @ Eliminate minor damage from rust or foreign materials by polishing surface with fine emery paper.

CAUTION: Use brake fluid to clean. PISTON Check piston for scoring, rust, wear, damage or foreign mate- rials. Replace if any condition exists.

CAUTION: Piston sliding surface is plated. Do not polish with emery paper even if rust or foreign materials are stuck to sliding surface.

PIN, PIN BOLT AND PIN BOOT

Check for wear, cracks or other damage. Replace if any condition exists.

Assembly @ Place piston boot over rear of piston. Fit piston boot'’s lip properly in corresponding groove on cylinder body. @ Insert piston into cylinder body and fit boot’s lip properly in corresponding groove on piston.

SBR480A

Inspection (On-vehicle)

INSPECTION OF BRAKE DRAG FORCE

1. Swing cylinder body upward.

2. Make sure that wheel bearing is adjusted properly. Refer to section FA.

3. Measure rotating force (F;).

SBR456A Install caliper with pads to original position. Depress brake pedal for 5 seconds. Release brake pedal and rotate disc rotor 10 revolutions. Measure rotating force (F:). CONDAL Calculate brake drag force by subtracting F; from Fo. Maximum brake drag force (F2 — F,):

59.8 N (6.1 kg, 13.5 Ib) If it is not within specification, check main pins and retainer boots in caliper. ' SBR457A

BR-15

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.