ox. (ff - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ox. (ff - Nissan 240SX 1991-1992 Workshop Manual
ox. (ff
PRECAUTIONS
e After disconnecting tubes, plug all openings immediately to prevent entrance of dirt and moisture.
CAUTION: e When installing an air conditioner in the vehicle, the pipes must be connected as the final stage of the operation. The seal caps of the pipes and other components must not be removed until their removal is required for connection. e Before installing any air conditioner component that has been stored in a cool location to a vehicle that has been Plug exposed to the hot sun, leave the component as it is for SHA058 some time in a hot location with its seal cap unremoved. This step is necessary to prevent condensation of moisture inside the cold component. e Thoroughly remove moisture from the refrigeration system before charging the refrigerant.
Apply O-ring Do not apply e Always replace used O-rings. compressor oi. compressor oil. e@ When connecting tube, apply compressor oil to portions shown in illustration. Be careful not to apply oil to threaded portion. e O-ring must be closely attached to inflated portion of tube.
-_ 5 portion
ox. (ff
SHA897A e After inserting tube into union until O-ring is no longer visible, tighten nut to specified torque. Union Nut e
After connecting line, conduct leak test and make sure that
there is no leakage from connections. When the gas leaking point is found, disconnect that line and replace the O-ring.
© CORNED
Then tighten connections of seal seat to the specified
4 J
SHA898A HA-17
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.