Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXWINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

WINDSHIELD AND WINDOWS

WINDSHIELD AND WINDOWS

Windshield REMOVAL INSTALLATION After removing moldings, @ Use genuine Nissan Sealant kit or equivalent. Follow instructions furnished with it. remove glass. e After installation, the vehicle should remain stationary for about 24 hours.

CAUTION: “WARNING: Be careful not to scratch glass when Keep heat and open flames away as primers are flammable. removing.

CAUTION: Cutting sealant Advise the user of the fact that vehicle should not be driven on rough roads or surfaces until sealant has properly vulcanized. @ Do not use sealant which is past its usable term. © Do not leave cartridge unattended with its cap open. @ Keep primers and sealant in a cool, dry place. Ideally, they should be stored in a refrigerator. @ Windshield glass should be installed within 15 minutes of applying sealant: sealant starts to harden 15 minutes after it is applied. ® Molding must be installed securely so that it is in position and leaves no gap. SBFO34B Glass side Body side

Install dam rubber & spacers with double-faced adhesive tape. Install spacers to panel with double-faced tape. Vehicle center Spacer = y 2528 so 25 (0.98) | a > \ Dam rubber ‘500 \ Unit: mm (in) . joint portion P adhesive Approximately

tape

8 mm (0.31 in)

a : Spacer mounting

Vehicle center

19.69)

portion SBF196E (Spacer should be installed at slit portion of dam rubber.) SBF198E Install molding fastener. When installing it, heat body panel and

Apply sealant evenly.

fastener to approx. 30 to 40°C (86 to

104°F). Upper & side molding fastener Unit: mm (in): Fastener More than 7 (0.28) Dam rubber (0.47) Double-faced 12 adhesive tape than SBF197E —— More

BF-61

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.