TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 5 — Hard to Start or
Impossible to Start when the Engine is Hot
No
CHECK FUEL PRESSURE.
Check fuel pump and cir- tv
1. Pinch fuel feed hose with fingers. cuit. (See page EF & EC- Fuel filter
2. When cranking the engine, is there OQ 152.) any pressure on the fuel feed hose? Yes
¢<Pinching fuel feed hose
F U4 v ~ SEF740K Yes
Check fuel properties.
CHECK FUEL VAPOR.
1. Disconnect fuel pressure regulator VAT TMX,\ NN asi
Pressure regulator
| | vacuum hose and plug hose. oN
2. Can you start engine? No Vv No
CHECK INJECTOR.
Check injector(s) and cir- Vv
1. Remove crank angle sensor from cuit(s). engine. (Crank angle sensor harness connector should remain connected.)
2. Disconnect ignition coil harness con- SEF838K nector.
3. Turn ignition switch ON. (Do not start co} engine.)
4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes 4 | Vv N.G.
CHECK IGNITION SPARK.
Check ignition coil, power Vv
1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.
2. Connect a known good spark plug to EC-114.) SEF837K the ignition wire.
3. Place end of spark plug against a suitable ground and crank engine. Ignition wire
4. Check for spark. O.K.
(Go to ® on next page.) Spark plug
SEF282G
EF & EC-66
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.