Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont’d)

REPLACEMENT OF CONNECTING ROD BUSHING (Small end) :

1. Drive in small end bushing until it is flush with end surface of rod. Be sure to align the oil holes.

2. After driving in small end bushing, ream the bushing so that clearance between small end bushing and piston pin is specified valve. Clearance between small end bushing and piston pin:

0.005 - 0.017 mm (0.0002 - 0.0007 in) SEM062A

FLYWHEEL/DRIVE PLATE RUNOUT

Runout (Total indicator reading): Flywheel (M/T model) Less than 0.15 mm (0.0059 in) Drive plate (A/T model) Less than 0.5 mm (0.020 in)

SEM261C Assembly PISTON

1. Install new snap ring on one side of piston pin hole.

SEM166B

2. Heat piston to 60 to 70°C (140 to 158°F) and assemble Front mark | Piston grade number piston, piston pin, connecting rod and new snap ring. e_ Align the direction of piston and connecting rod. e Numbers stamped on connecting rod and cap correspond to each cylinder. e After assembly, make sure connecting rod swings smoothly.

Cylinder number \ SEM311D

3. Set piston rings as shown. Punchmark side

CAUTION: up if present @ When piston rings are not being replaced, make sure that a5 piston rings are mounted in their original positions. @ When piston rings are being replaced and no punchmark is present, piston rings can be mounted with either side up.

SEM264C EM-42

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.