TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 31 (Cont'd)
INSPECTION START
([__c7untt fol CONNECTOR |
ab Vv
N.G. || Repair harness or con-
ale
CHECK INPUT SIGNAL CIRCUIT.
7 | 1) Disconnect E.C.U. harness connector nectors. and detonation sensor sub-harness connector. 2) Check harness continuity between terminal ® and E.C.U. terminal @). MEF698A Continuity should exist. O.K. Vv N.G. || Replace detonation sen-
CHECK COMPONENT
(Detonation sensor). sor. Refer to “Electrical Components Inspection’. (See page EF & EC-168.) O.K. Vv Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
Perform FINAL CHECK by the following procedure after repair
is completed.
FINAL CHECK
Vv Erase the self-diagnosis memory.
Vv Perform test drive.
Vv N.G. > Recheck E.C.U. pin termi- Perform self-diagnosis again. nals for damage or the O.K. connection of E.C.U. har- ness connector.
v
INSPECTION END
EF & EC-120
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.