Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

Evacuation (Cont'd) MAINTENANCE If inadequate airtightness is detected, check and service the following portions:

Leak from pipe jointsLeak from manifold gauge set
e Contaminated, damaged, or de-e Malfunctioning hose
formed O-ringe Improper installation of manifold
e@ No oil applied when connectinge Malfunctioning valve
pipee Malfunctioning packing
e Excessive or insufficient tighten-
ing of pipe joint

EVACUATION If no abnormality is found during the airtightness check, perform evacuation again for more than 20 minutes.

1. Run the vacuum pump.

2. Open the high and low pressure valve and vacuum pump valve of the manifold gauge set.

3. Evacuate for more than 20 minutes.

4. Close the high and low pressure valves and vacuum pump valve of the manifold gauge set.

Charging Refrigerant

Install the charging cylinder correctly to the vehicle. Refer to “Setting of Service Tools’.

PRELIMINARY CHARGING OF REFRIGERANT-1

1. Make sure that the inlet and outlet valves of the charging cylinder are closed.

2. Slowly open the outlet valve of a refrigerant container [13.6 kg (30 Ib)].

3. Slowly open the inlet valve of the charging cylinder. The refrigerant will flow into the sight glass of the charging (slowly cylinder as the valve is opened. open) Outlet Inlet valve (slowly open) valve (close) BHA677B

4. Slowly open the upper vent valve to release pressure from Vent valve the charging cylinder. While doing so, continue charging (stowly open) until the required amount of refrigerant is reached. ;t The refrigerant volume changes with the temperature and ae oe eo pressure. It is necessary to charge refrigerant with a little more or oe than the required amount (indicated on the sight glass). ey Lo

5. Close the inlet valve and upper vent valve of the charging E cylinder. Sight glass RHA678B HA-30

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.