Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 2

& Push control unit SYMPTOM: Air outlet does not change. connector @ Perform PRELIMINARY CHECK 4 and Main Power Supply and Ground Circuit Check before referring to the following flow chart. (5 N.G. Disconnect mode door motor

CHECK MODE DOOR MO-

harness connector.

TOR POSITION SWITCH.

1. Turn VENT switch ON with B Vv Note RHA410A ignition switch at ACC BI position.

CHECK BODY GROUND

Mode door motor

2. Turn ignition switch OFF

CIRCUIT FOR MODE DOOR

connector (130)

(ay . q “ 5 HS. Disconnect push control unit MOTOR. Oo

PL TTI IT

LJ} somes connector. Does continuity exist between [; E>

3. Check if continuity exists mode door motor harness termi- between terminal No. @ or

nal No. @ and body ground?

(2) of push control unit har- (i

ness connector and body

O.K. Note 4 ground. Check circuit continuity be-

4. Using above procedures, tween each terminal on push = RHAGIIA check for continuity in any contro] unit and on mode door other mode, as indicated in motor, Push control unit chart. s, connector (0) (VT 1 Xe \orl og} . Terminal No. Conti- \ | S “f

y. Mode Terminal No. |oongi- aa) =) nuity 1 \—\ | switch nuity

E ae fe) =

DISCONNECT ® S) aes &> VENT |@Mor® Push control | Mode door 3,5]7 unit motor I ~ B/L @ or @) O ® " Body FOOT @B or @ ground Yes @ @ F/D @ or ® @ @ Yes DEF S or © @ ® Aas xv O.K. oO ©) ® v © © Mode door motor @ ® Refer to DOOR CONTROL.

+ @ (Go to next page.) Note: If the result is N.G. after checking circuit continuity, repair harness or connector. HA-85

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.