TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 35 (Cont'd)
Ee [wecrnrT fel comeecron
|
INSPECTION START
[cant (ol caeecion] a
11.10 12
[Lerner fof conmsecronr |]
[_cAnrr [el comector |
12 42 44 v \(@ mm ay
CHECK INPUT SIGNAL CIRCUIT. | N.G. || Check the following.
1) Disconnect E.C.U. harness e@ Harness connectors (5) , [a] connector and A/T control e Harness continuity between 4 } unit harness connector. E.C.U. and A/T control unit (esa) 2) Check harness continuity be- If N.G., repair harness or con- - }
tween E.C.U. terminal @2 and
nectors. MEFTO3A terminal @, E.C.U. terminal @2) and terminal 40, E.C.U. terminal and terminal (7). Continuity should exist. O.K. Vv Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
Perform FINAL CHECK by the following procedure after repair is completed.
FINAL CHECK
Vv Erase the self-diagnosis mem- ory.
v Perform test drive.
v Perform self-diagnosis again. N.G. || Recheck E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
Vv
INSPECTION END
EF & EC-143
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.