Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTIME CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

TIME CONTROL SYSTEM

TIME CONTROL SYSTEM

Trouble-shooting (Cont'd)

DIAGNOSTIC PROCEDURE-5

Light warning chime does not activate.

Do other warning chimes O.K. activate? N.G. Vv

Go to ‘‘Power Supply Circuit

N.G. Check harness for T.C.U.

Check”. "| power supply circuit. O.K. Vv Check T.C.U. output for chime N.G. Check chime, and harness circuit. "| between T.C.U. and chime. O.K. ‘ +

N.G. | Check harness between

Go to “T.C.U. output for light

“| T.C.U. and light switch. switch circuit check”’. (Refer to back page.) O.K. v Replace T.C.U.

DIAGNOSTIC PROCEDURE-6

T.C,U, OUTPUT FOR CHIME CIRCUIT

CHECK Seat belt warning chime does not activate. Measure voltage across (9) and (5) when driver’s door is opened and closed. — ~ wat Go to ‘Power Supply Circuit ““" | Check harness for T.C.U. power

EERE PRE

(Gr) . Check”’. “|

supply circuit.

O.K. Approx. 12V when @ @ y driver's side door is closed. ; Voltmeter needle swings e

(0 = 12V) when driver's

Check T.C.U. output for chime

O.K.

Check chime, and harness

bo side door is opened. aL circuit. between T.C.U. and chime. N.G.

[=] SEAT BELT SWITCH CIRCUIT CHECK

BI a

1. Unfasten driver's seat belt. N.G.

Check harness between T.C.U.

p|

Check seat belt switch circuit.

2. Check continuity between (9) and (6).

3. Fasten driver’s seat belt. and seat belt switch.

4. Check to determine if continuity does not O.K. exist between and (6) . ¥ Replace T.C.U.

SEL643L

EL-69

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.