ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
Rear Wheel Alignment (Cont'd)
TOE-IN
1. Draw a base line across the tread. After lowering rear of vehicle, move it up and down to eliminate friction.
SMA123
2. Measure toe-in. Lines parallel to Measure distance “A” and ‘‘B” at the same height as hub center. center line of body Toe-in: Refer to S.D.S.
0
Front Toe-in=A—B SFA234A (3) Total toe-in angle = 206
3. Adjust toe-in by turning adjusting bolts. Toe changes about 1.5 mm (0.059 in) [One side] with each graduation of the adjusting bolt.
4. Tighten to the specified torque. (): 69 - 88 Nem (7.0 - 9.0 kg-m, 51 - 65 ft-lb) Adjusting bolt II | Toe-in
ey er
| ; Lower link
VA S\ Dixf[- Ww
La SRA217A
Drive Shaft
Check boot and drive shaft for cracks, wear, damage or grease leakage.
SRA796
RA-7
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.