REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
REAR AXLE — Drive Shaft
REAR AXLE — Drive Shaft
Assembly (Cont'd)
2. Install spider assembly securely, making sure marks are properly aligned. Press-fit with spider assembly serration chamfer facing shaft. a
3. Install new snap ring. ess Suitable tool
Chamfer SFA397
4. Install coil spring, spring cap and new plug seal to slide joint housing. Press plug seal. Apply sealant to mating surface of plug seal.
CAUTION:
a. When pressing plug seal into place, hold it horizontal so that spring inside it does not tilt or fall down.
b. Move shaft in axial direction to ensure that spring is installed properly. If shaft drags or if spring is not installed properly, remove plug seal and install a new one. Discard plug seal after removal.
SRA123A
5. Pack drive shaft with specified amount of grease. Specified amount of grease: 185 - 195 g (6.52 - 6.88 oz)
6. Set boot so that it does not swell and deform when its length is “L:’. Length “L,”: 110.5 - 112.5 mm (4.35 - 4.43 in) Make sure that boot is properly installed on the drive shaft groove.
SRA124A
Boot band SFA395
RA-17
Parts & tools for this job For Nissan 240SX
- PARTRear wheel bearingSearch: Nissan 240SX rear wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Nissan 240SX cv boot kit
As an Amazon Associate we earn from qualifying purchases.