Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Assembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAssembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Assembly (Cont'd)

ASSEMBLY

Assembly (Cont'd)

j. Install lock-up solenoid and fluid temperature sensor con- nectors. Connector

13. Install oil pan.

a. Attach a magnet to oil pan.

—s ;

SAT011B

b. Install oil pan gasket on transmission case.

c. Install oil pan and bracket on transmission case. @ Tighten four bolts in a criss-cross pattern to prevent dislocation of gasket.

SAT012B

14. Install inhibitor switch.

a. Check that manual shaft is in “1” range. Temporarily install inhibitor switch on manual shaft. a

c. Move manual shaft to “N”.

SAT013B

d. Tighten bolts while inserting 4.0 mm (0.157 in) dia. pin vertically into locating holes in inhibitor switch and manual shaft.

AT-183

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.