BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › BRAKE BOOSTER - Nissan 240SX 1991-1992 Workshop Manual
BRAKE BOOSTER
BRAKE BOOSTER
Removal and Installation
Clevis pin
(0) 13 - 16 (1.3 - 1.6, 9- 12)
0) : N-m (kg-m, ft-lb)
Brake booster
O)s-11 (0.8 - 1.1, 5.8 - 8.0) SBR473A Inspection
OPERATING CHECK
Depress brake pedal several times with engine off, and check that there is no change in pedal stroke. Depress brake pedal, then start engine. If pedal goes down slightly, operation is normal.
SBROO2A
AIRTIGHT CHECK
Start engine, and stop it after one or two minutes. Depress brake pedal several times slowly. If pedal goes further down the first time and gradually rises after second or third time, booster is airtight. Depress brake pedal while engine is running, and stop engine with pedal depressed. If there is no change in pedal stroke after holding pedal down 30 seconds, brake booster is airtight.
OUTPUT ROD LENGTH CHECK
1. Supply brake booster with vacuum of -66.7 kPa (-500 mmHg, —19.69 inHg) using a handy vacuum pump.
2. Check output rod length. Specified length:
10.275 - 10.525 mm (0.4045 - 0.4144 in)
SBR281A BR-8
Parts & tools for this job For Nissan 240SX
- PARTBrake padsSearch: Nissan 240SX brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.