Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

QUICK REFERENCE INDEX: C: QUICK CHARGE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › QUICK REFERENCE INDEX: C: QUICK CHARGE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXQUICK REFERENCE INDEX: C: QUICK CHARGE - Nissan 240SX 1991-1992 Workshop Manual

QUICK REFERENCE INDEX: C: QUICK CHARGE

BATTERY Battery Test and Charging Chart (Cont'd)

C: QUICK CHARGE

Fig. 6 INITIAL CHARGING CURRENT SETTING AND

CHARGING TIME (Quick charge)

BATTERY | _ _

~ nm] eee] Oe a ee eee eee = a See ees mr tzjrrtTTtaijrTroa x TYPE | == acaam; acaa;yeocoe - co Determine initial charging current setting and CUR- 22 Saal Adalong Ay} charging time from specific gravity, referring CON- RENT a < © io Q a Q Q a Q r 8 to Fig.

6. VERTED \[a] \|%? [| TOV, Perr e@ 7 SPECIFIC GRAVITY 10 (A) 15 (A) 20 (A) 30 (A) 40 (A) ,

1.100 - 1.130

2.5 hours ‘

1.130 - 1.160

2.0 hours Charge battery

1.160 - 1.190

1.5 hours |

1.190 - 1.220

1.0 hours

Go to “CAPACITY TEST”.

0.75 75

hours (48 min.)

Ab ove

1.220

5 min. e@ Check battery type and determine the specified current using the table shown above. e After starting charging, adjustment of charging current is not necessary.

CAUTION:

a. Do not use quick charge method on a battery whose specific gravity is less than 1.100.

b. Set initial charging current to value specified in Fig. 6. If charger is not capable of producing specified current value, set its charging current as close to that value as possible.

c. Keep battery away from open flame while it is being charged.

d. When connecting charger, connect leads first, then turn on charger. Do not turn on charger first, as this may cause a spark.

e. Be careful of a rise in battery temperature because a large current flow is required during quick-charge operation. If battery temperature rises above 60°C (140°F), stop charging. Always charge battery when its tem- perature is below 60°C (140° F).

f. Do not exceed the charging time specified in Fig. 6, because charging battery over the charging time can cause deterioration of the battery.

Service Data and Specifications (S.D.S.)

Applied areaU.S.A.Canada
Type55D23R65D26R
CapacityV-AH12-6012-65

EL-14

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.