Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 3

Intake door does not change in VENT, B/L or

Intake door motor as) SYMPTOM: connector (156 H.S. FOOT mode.

@ Perform PRELIMINARY CHECK 1 and Main Power Supply

DISCONNECT €

and Ground Circuit Check before referring to the following

flow chart. (a

Check 10A fuses at fuse block.

N.G.

CHECK POWER SUPPLY

RHA414A

'|(Refer to “POWER SUPPLY

FOR INTAKE DOOR

ROUTING” in EL section and A/C MOTOR. Ae (

ELECTRICAL CIRCUIT.)

Disconnect intake door motor harness connector. Do approx. 12 volts exist be- Intake door motor tween intake door motor harness connector (158 terminal No. (0 and body |_| x 9} ground? G/B ON O.K. B : (-) ® N.G. Disconnect push control unit

CHECK BODY GROUND

harness connector.

CIRCUIT FOR INTAKE

DOOR MOTOR.

Intake door motor , Note Does continuity exist between connector intake door motor harness ter- Check circuit continuity be- DX]. 11

minal No. Q) and body ground

tween push control unit harness /

terminal No. @) (()) and intake

when REC switch is ON? Does continuity exist between door motor harness terminal oO ® No. @ (@). intake door motor harness

terminal No. (i) and body

Continuity should exist when O.K. test leads are connected as ground when REC switch is shown, it should not exist when = Vv OFF? Replace control amp. built-in test leads are reversed. RHAS58C push control unit. O.K. Vv Push control unit Replace intake door motor. connector me) fe) Li i | i J jets |

GiB | jew

Intake door

(OF motor connector Ga eo

RHA898A

Note:

If the result is N.G. after checking circuit continuity, repair harness or

connector.

HA-83

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.