TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 32 (Cont’d)
INSPECTION START
trMONITOR NO FAIL [_]
EGR TEMP SEN
3.1V Vv N.G.
,| Repair harness or con- | 1) Start engine and warm it up suffi- nectors. ciently. = 2) Read exhaust gas tempera- ture sensor signal in “DATA [RECORD MONITOR” mode with CON- SULT. SEF5891 Voltage: Less than 4.5V (at idle) DISCONNECT &) OR € GEIL, 2) Stop engine. 3) Disconnect exhaust gas tem- perature sensor sub-harness \. lary connector (51) . 4) Turn ignition switch ‘‘ON’’. <1 @ 5) Check voltage between termi- nal @) and ground. Voltage: MEF699A Less than 4.5V (at idle)
CHECK POWER SUPPLY.
ap Me
@ O.K. Vv N.G.
,| Repair harness or con- [Q] yr 1) Turn ignition switch ‘““OFF”’. nectors. 2) Check harness continuity between terminal @ and engine ground. Continuity should exist. O.K. MEF700A Vv N.G.
CHECK GROUND CIRCUIT.
CHECK COMPONENT.
,| Replace exhaust gas (Exhaust gas temperature sensor). temperature sensor. Refer to ‘Electrical Components Inspection’. (See page EF & EC-166.) O.K. Vv Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
EF & EC-122
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.