Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

SYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › SYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSYSTEM DESCRIPTION — Push Control - Nissan 240SX 1991-1992 Workshop Manual

SYSTEM DESCRIPTION — Push Control

SYSTEM DESCRIPTION — Push Control

Intake Door Motor

The intake door motor is installed on the front portion of the intake unit. Using a rod and link it opens and closes the intake door. When the REC switch is ON (OFF), the ground line of the intake door motor is switched from terminal () to @) (@ to ()). This causes the motor to start because the position switch contacts built into it are set to the current flow position. The contacts turn along with the motor. When they reach the non-current

IGNITION SWITCH

flow position, the motor will stop. The motor always turns in the ACC or ON same direction. Intake door motor ot | [LOD<I 9 [1]

To push control

Mode Door Motor

The mode door motor is located on the left side of the heater unit. Through the side link it opens and closes the vent, foot and defroster door. When one mode switch is pushed, the position switch built into it reads the corresponding mode to determine the direction of motor rotation. As soon as the desired mode is set, the position switch stops the motor. Mode door motor [eo] (227615 [4 [3[ 211 xi? [8] *: Current flows as indicated by the arrow, motor actuates as indi- cated by the words. To push < control me

Terminal No. Mode door motor

Mode door

Direction

of linkage

. ® operation ; rotation (S) >) Stop Stop S) @ VENT—>DEF | Clockwise Counter- ©

clockwise ©

DEF VENT

RHA380A

HA-103

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.