Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Adjustment (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Adjustment (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXAdjustment (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Adjustment (Cont'd)

ASSEMBLY

Adjustment (Cont'd)

c. With original thrust washer installed on oil pump, place shim T setting gauge legs onto machined surface of oil pump — assembly and allow gauging plunger to rest on thrust — — ¥ washer. Lock plunger in place with set screw.

SAT983A

d. Use feeler gauge to measure gap between gauging plunger and gauging cylinder. This measurement should give you exact reverse clutch drum and play. Reverse clutch drum end play “T:”:

0.55 - 0.90 mm (0.0217 - 0.0354 in) @ lf end play is out of specification, decrease or increase thickness of oil pump thrust washer as necessary. Available oil pump thrust washer: Refer to S.D.S. Feeler gauge SAT984A Assembly

1. Install output shaft and parking gear.

a. Insert output shaft from rear of transmission case while slightly lifting front internal gear. @ Do not force output shaft against front of transmission case.

b. Carefully push output shaft against front of transmission case. Install snap ring on front of output shaft. @ Check to be sure output shaft cannot be removed in rear direction. Pliers location

c. Install needle bearing on transmission case. @ Pay attention to its direction — Black side goes to rear. @ Apply petroleum jelly to needle bearing.

AT-167

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.