POWER STEERING OIL PUMP - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › POWER STEERING OIL PUMP - Nissan 240SX 1991-1992 Workshop Manual
POWER STEERING OIL PUMP
POWER STEERING OIL PUMP
Disassembly (Cont'd) Remove snap ring, then draw pulley shaft out. @ Be careful not to drop pulley shaft.
Extension bar
Litton Drive shaft
SST010B @ Remove oil seal. Be careful not to damage front housing.
Remove connector. @ Be careful not to drop flow control valve.
Flow control valve SSTO36A Inspection
PULLEY AND PULLEY SHAFT
If pulley is cracked or deformed, replace it. @ If an oil leak is found around pulley shaft oil seal, replace the @ seal. If serration of pulley or pulley shaft is deformed or worn, @ replace it.
Assembly Assemble oil pump, noting the following instructions. x Make sure O-rings and oil seal are properly installed. @ \ x Always install new O-rings and oil seal. @ Be careful of oil seal direction. Cam ring, rotor and vanes must be replaced as a set if @ necessary. Coat each part with A.T.F. when assembling. @
SSTO38A ST-25
Parts & tools for this job For Nissan 240SX
- PARTOil filterSearch: Nissan 240SX oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Nissan 240SX engine oil
As an Amazon Associate we earn from qualifying purchases.