ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
ENGINE MAINTENANCE
ENGINE MAINTENANCE
Changing Engine Coolant
WARNING: To avoid being scalded, never change the coolant when the Y Y\\-| ol]]/o
(=| [sla alele
alofo}jol]sa engine is hot.
1. Move heater ‘‘TEMP”’ control lever all the way to ‘‘HOT’’ =o [#012 3 4 o position.
2. Remove undercover.
SMA003C Open drain plug at the bottom of radiator, and remove radiator cap.
Remove drain plug on cylinder block. Close drain plug and tighten drain plug securely. Apply sealant to the thread of drain plug. en (0): 34 - 44 N-m (3.5 - 4.5 kg-m, 25 - 33 ft-lb) .
\ ater drain plug 1 \onere SMA364C Open air relief plug. Fill radiator with water and close air relief plug and radia- as tor Cap. acetate Air relief valve
8. Run engine and warm it up sufficiently.
9. Race engine 2 or 3 times under no-load.
10. Stop engine and wait until it cools down.
11. Repeat step 2 through step 9 until clear water begins to drain from radiator. M
12. Drain water. Radiator upper hose
MA-9
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.