Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

FUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › FUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXFUEL INJECTION CONTROL SYSTEM INSPECTION - Nissan 240SX 1991-1992 Workshop Manual

FUEL INJECTION CONTROL SYSTEM INSPECTION

FUEL INJECTION CONTROL SYSTEM INSPECTION

Fuel Pressure Check (Cont'd)

NTM~N / Ji (tM \ so

5. Read the indication of fuel pressure gauge. At idling: Pressure regulator When fuel pressure regulator valve vacuum hose is connected.

Approximately 235 kPa (2.4 kg/cm’, 34 psi)

When fuel pressure regulator valve vacuum hose is disconnected.

Approximately 294 kPa (3.0 kg/cm’, 43 psi)

SEF838K Stop engine and disconnect fuel pressure regulator vacuum

6. hose from intake manifold. Plug intake manifold with a rubber cap. |

7. Connect variable vacuum source to fuel pressure regulator.

8.

Start engine and read indication of fuel pressure gauge as

9. vacuum is changed. Fuel pressure Vacuum

Fuel pressure should decrease as vacuum increases. If results

are unsatisfactory, replace fuel pressure regulator.

SEF718B ' Engine front Injector Removal and Installation rreseure regulator 6 a a |

1. Release fuel pressure to zero. NI

Fuel injector

2.

Remove related covers, harnesses, wires and tubes.

Remove injector tube assembly with injectors from intake

3. manifold. Remove injectors from injector tube assembly. . Push injector tail piece. Do not pull on the connector. Install injectors as follows: Clean exterior of injector tail piece. ee SEF744K Use new O-rings mo=-oT1eer ~~

CAUTION:

After properly connecting injectors to fuel tube assembly, check

connections for fuel leakage. Assemble injectors to injector tube assembly.

6. Install injector tube assembly to intake manifold.

7.

EF & EC-192

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.