Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 15 1 Sw O/D 7 OFF

SYMPTOM: Engine speed does not return to idle

Self-diagnosis smoothly when A/T is shifted from D, to Ds Start

with accelerator pedal released.

Vehicle does not decelerate by engine i brake when changing overdrive switch to “OFF” position with accelerator pedal released. Vehicle does not decelerate by engine sarees

brake when changing selector lever from

Throttle sensor and ¥ | | v~ “D” to 2” range with accelerator pedal KY throttle valve switch zg . released. (fie f

Does self-diagnosis show damage

Yes

Check overrun clutch solenoid

=~ to overrun clutch solenoid circuit circuit. — Refer to ‘’Self- ant /

after cruise test?

diagnosis”’.

Air duct

2 | No v — SAT739D N.G. Check throttle sensor. — Refer >! Repair or replace throttle sensor. to section EF & EC. O.K. 1

1. Remove oil pan. N.G.

2. Check A/T fluid condition. “| | 1. Remove control valve assem- bly. — Refer to ‘“ON-VEHI- OK.

CLE SERVICE”.

>!

2. Check the following items. @ Overrun clutch control valve @ Overrun clutch reducing valve O.K. @ Overrun clutch solenoid D O.K. 4] h

3. Disassemble A/T. 8/8 T —2

4. Check the following items. yy, @ Overrun clutch assembly a 2 @ Oil pump assembly oa -_— a 7

‘ oo Leo Check again. —»|

1. Perform A/T control unit 1 cn input/output signal inspection. O.K <—t TM

2. If N.G., recheck A/T control 0/8 ‘ Q v nae ; unit pin terminals for damage

INSPECTION END

or connection of A/T control

unit harness connector.

(

D3 (O.D. OFF)

Engine brake SAT765B AT-72

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.