Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 39 (Cont'd)

INSPECTION START

’ O.K.

CHECK OVERALL FUNCTION.

INSPECTION END

1) Turn ignition switch ‘‘ON”’. 2) Listen to fuel pump operating sound. Fuel pump should operate for 5 seconds after ignition switch is turned “ON’’. SEF9801 N.G. B y B| : DISCONNECT om la €) N.G. 25

CHECK POWER SUPPLY.

Check the following. Vv 1) Turn ignition switch “‘OFF’’. e 10A fuse 1 2) Disconnect fuel pump relay. e Harness continuity between 3) Turn ignition switch ““ON”’. fuse and fuel pump relay 4) Check voltage between termi- lf N.G., repair harness or con- nals @, ® and ground. nectors. <4) Voltage: Battery voltage 4, O.K. Y N.G.

CHECK GROUND CIRCUIT.

Check the following. Vv MEF709A 1) Turn ignition switch ‘OFF’. e Harness connectors (1!) , 2) Disconnect fuel pump harness e Harness continuity between connector. fuel pump and body ground od 3) Check harness continuity be- e@ Harness continuity between

tween terminal @ and body

fuel pump and fuel pump relay ground, terminal ©) and ter- If N.G., repair harness or con- minal @). nectors. Continuity should exist. D ’ O.K. N.G.

CHECK OUTPUT SIGNAL CIR-

Check the following. Vv CUIT. e Harness connectors(?), 1) Disconnect E.C.U. harness e Harness continuity between connector. E.C.U. and fuel pump relay 2) Check harness continuity be- If N.G., repair harness or con- tween E.C.U. terminal@oDand nectors. terminal @. f . Continuity should exist. lO.K.;

MEF710A

ma a

CANIT a— ER

€) 4€

MEF711A

EF & EC-153

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.