Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

CHECK AND ADJUSTMENT — On-vehicle

CHECK AND ADJUSTMENT — On-vehicle

Rear Wheel Alignment (Cont’d) Upper link rear lf camber is not within specification, adjust by turning the adjusting pin. (1) Turn the adjusting pin to adjust. Camber changes about 5’ with each graduation of the adjusting pin. Negative (2) Tighten to the specified torque. camber Adjusting bolt (): 69 - 88 Nem (7.0 - 9.0 kg-m, 51 - 65 ft-lb)

‘\ \ SRAO98BA TOE-IN

1. Draw a base line across the tread. After lowering rear of vehicle, move it up and down to eliminate friction.

SMA123

2. Measure toe-in. . Lines parallel to Measure distance “A” and “B” at the same height as hub center line of body center. Toe-in: A-B

0.5 - 4.5 mm (0.020 - 0.177 in) KS B F) , 24 (Total toe-in) 3’ - 25! Front SFA234A 6 Total toe-in = 26

3. Adjust toe-in by turning adjusting pins. If AN / Toe changes about 1.5 mm (0.059 in) [One side] with each graduation of the adjusting pin.

4. Tighten to the specified torque. (): 69 - 88 Nem (7.0 - 9.0 kg-m, 51 - 65 ft-lb) Adjusting bolt | II t t

Toe-in [7

Lower link U =~ SRA217A/

Drive Shaft

Check boot and drive shaft for cracks, wear, damage or grease leakage.

Ki 6

SRA796

RA-7

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.