SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 2 (Cont'd)
SYMPTOM (B):
Warning lamp comes on when ignition switch is turned ON;
however, it does not go out after engine start.
[ fy SELECT DIAG MODE
| SELF-DIAG RESULTS
[ DATA MONITOR
START
[ ACTIVE TEST
[ ECU PART NUMBER
[ Vv | O.K. . No engine rpm signal is en- Check in self-diagnosis mode. Vv Refer to page ST-54. tered. I Warning lamp N.G. Vv @) remains ON Repair malfunctioning part de- Vv tected by self-diagnosis. Refer to Diagnostic Procedures 5 to 11. | Vv @) |B} 4 No No power is supplied to control Check rear wheel action. Vv Left and right rear wheels are unit.
turned in response to rotation of
SST460B steering wheel. Refer to page ST-49. Yes Vv Insufficient oil quantity.
4. ~~ A 4 Replace fluid level sensor (on A reservoir tank) if warning lamp remains on during engine oper- ation.
ST-62
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.