Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Assembly (Cont'd)

Oil ring e@ Top ring a ri Oil expande Fxg

Front VA

\ yo /

Qe ZB oles

lower rail SEM160B CRANKSHAFT

wy. 5v No.

Set main bearings in their proper positions on cylinder

1. TM) block and main bearing beam. Confirm that correct main bearings are used. Refer to “Inspection” of this section. ~ v g No. 2 Mg No. 1 Front SEM448C Install crankshaft and main bearing beam and tighten bolts to the specified torque. Prior to tightening bearing cap bolts, place bearing cap in its proper position by shifting crankshaft in the axial direc- ia tion. Tighten bearing cap bolts gradually in two or three stages. Start with center bearing and move outward sequentially. After securing bearing cap bolts, make sure crankshaft turns smoothly by hand.

Measure crankshaft end play. Crankshaft end play: Standard

0.05 - 0.18 mm (0.0020 - 0.0071 in) Limit

0.3 mm (0.012 in) If beyond the limit, replace bearing with a new one.

SEM158B Install connecting rod bearings in connecting rods and con- necting rod caps. Confirm that correct bearings are used. Refer to “Inspection”’. Install bearings so that oil hole in connecting rod aligns with oil hole of bearing.

SEM159B EM-43

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.