TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 34 (Cont’d)
Perform FINAL CHECK by the following procedure after repair
is completed.
FINAL CHECK
Vv Erase the self-diagnosis memory. Make sure Code No. 55 is displayed in Mode I.
B) Vv Clear the self-learning data using the following procedure: 1) Start engine and warm it up suffi- ciently. cy\ 2) Select “SELF- LEARNING CONT” in “ACTIVE TEST”’ mode. 3) Clear the self-leaning control coefficient by touching “CLEAR” OR
®) . connector, and restart and
2) Disconnect air flow meter
run engine for at least 30 sec- onds at 2,000 rpm. 3) Stop engine and reconnect air flow meter connector. 4) Make sure Code No. 12 is dis- played in Mode T. 5) Erase the self- diagnosis memory. Make sure Code No. 55 is displayed in Mode IL
y Perform engine racing test as indicated
in figure @.
Comes DI ¥y on. Make sure that check engine light does Recheck E.C.U. pin termi- Vv not come on during engine test. nals for damage or the connection of E.C.U. har- Does not come on. ness connector.
y
INSPECTION END
EF & EC-128
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.