TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Control Linkage Adjustment
MODE DOOR
1. Move side link with hand and hold mode door in VENT mode.
2. Install mode door motor on heater unit and connect it to body harness.
3. Turn ignition switch to ON.
4. Turn VENT switch ON. |
5. Attach mode door motor rod to side link rod holder.
6. Turn DEF switch ON. Check that side link operates at the fully-open position. Also turn VENT switch ON to check that side link operates at the fully-open position.
Mode door motor S|
RHAS68C
WATER COCK CONTROL ROD
@ When adjusting water cock control rod, first disconnect temperature control cable from air mix door lever. Re- connect and readjust temperature control cable. Push air mix door lever in direction of arrow. —_- Pull control rod of water cock in direction of arrow so as to (ofrRy N give a clearance of about 2 mm (0.08 in) between ends of rod and link lever. Connect control rod to door lever. After connecting control rod, check it operates properly.
TEMPERATURE CONTROL CABLE
@ When disconnecting control cable, remove E-ring and take off cable while pushing cable outer. @ Move temperature control lever to full hot position. Push air mix door lever in direction of arrow. Pull on outer cable in direction _of arrow and then clamp it. After positioning control cable, check it operates properly.
RHA376A
Air mix
ir mix door lever evel
HA-95
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.