Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 8

Revolution sensor

AIL O/D

1

Speed sensor SYMPTOM: Vehicle cannot be started from D; on AS OFF Shift solenoid A Cruise test — Part 1. Shift solenoid B Self-diagnosis start

ls Diagnostic Procedure 7 O.K.?

Ne >! Go to Diagnostic Procedure 7.

; yr Yes i a

Yes > Check damaged circuit. — Refer

Does self-diagnosis show damage

— UUULILIL.

to ‘’Self-diagnosis’’.

to revolution sensor, speed

Shade

sensor, shift solenoid A or B SAT760B after cruise test? Vv Throttle sensor and ¥ | | No throttle valve switch ©,

Check throttle sensor. — Refer to LVS, Repair or replace throttle sensor.

section EF & EC. OK.

{|N-S.

Check line pressure at stall point

>| | 1. Remove control valve assem-

with selector lever in ‘“’D’”’ range.

" bly. — Refer to ‘““ON-VEHI- — Refer to ‘““PRESSURE , TESTING”.

CLE SERVICE -

2. Check the following items.

@ Shift valve A

O.K. | @ Shift valve B .

1. Remove oil pan. O.K. .| @ Shift solenoid A

2. Check A/T fluid condition. ®@ Shift solenoid B N.G. .| | @ Pilot valve O.K. | | © Pilot filter < O.K.

3. Disassemble A/T.

4. Check the following items. @ Forward clutch assembly @ Forward one-way clutch @ Low one-way clutch @ High clutch assembly @ Torque converter @ Oil pump assembly ‘

NG, 1. Perform A/T control unit

Check again.

input/output signal inspection.

2. If N.G., recheck A/T control. | O.K. unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector. SAT171B

AT-66

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.