Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

Installation @ Drive plate runout Maximum allowable runout:

0.5 mm (0.020 in) If this runout is out of allowance, replace drive plate with ring gear.

@ When connecting torque converter to transmission, measure distance “A” to be certain that they are correctly assembled. Distance ‘‘A”’: 26 mm (1.02 in) or more N = 7 As @ Install converter to drive plate.

fay \\ AN

bee @ Reinstall any part removed. @ After converter is installed to drive plate, rotate crankshaft yA Distance A AS several turns and check to be sure that transmission ib rotates freely without binding.

QS alg

§ ») \\ <—

Q TAL Al —srrovre

@ Tighten bolts securing transmission. © : A/T> Engine © @ : Engine (gusset) © to A/T

Bolt No.Tightening torque N-m (kg-m, ft-lb)oe en) L
139 - 49 (4.0 - 5.0, 29 - 36)40 (1.57)
339 - 49 (4.0 - 5.0, 29 - 36) 29 - 39 (3.0 - 4.0, 22 - 29)50 (1.97) 25 (0.98)
329 - 39 (3.0 - 4.0, 22 - 29)25 (0.98)
Gusset to
engine29 - 39 (3.0 - 4.0, 22 - 29)20 (0.79)
(4 bolts)

OD) Go TO) 9) @) & e) (3) © SAT111C Reinstall any part removed. @ Check fluid level in transmission. @ Move selector lever through all positions to be sure that > transmission operates correctly. With parking brake applied, rotate engine at idling. Move selector lever through “‘N”’ to “D’’, to “2”, to “1” and to “R”’. A slight shock should be felt by hand gripping selector each time transmission is shifted. é @ Perform road test. — Refer to ‘ROAD TESTING”. SAT638A

AT-105

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.