PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
PARKING BRAKE CONTROL
PARKING BRAKE CONTROL
Removal and Installation
/, R.H. rear cable
Lock plate
Control lever
SBR487A REMOVAL Before removing parking brake control, remove console box. Loosen cable using control lever adjuster, and separate front and rear cables. Break clinched portion of control lever using a hammer and chisel as shown in figure at left, and replace cables with new parts. Front cable Apply multi-purpose grease to areas between control lever drum and cables. Control lever SBR488A INSTALLATION Be careful not to damage boot and inner cable. @ When installing parking brake cable at rear caliper, make sure to align matchmark on parking cable stay and cable.
Cable guide
Matchmark S|
Cable _} cutout portion SBR489A Inspection Check control lever for wear or other damage. Replace if
1. necessary. Check parking brake cables, lamp and switch. Replace if
2. necessary. Check parts at each connecting portion for deformation or damage. If found, replace.
BR-23
Parts & tools for this job For Nissan 240SX
- PARTBrake padsSearch: Nissan 240SX brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.