REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body (Cont'd)
b. Remove retainer plates while holding spring.
c. Place mating surface of valve facedown, and remove internal parts. @ If a valve is hard to remove, lightly tap valve body with a soft hammer. e@ Be careful not to drop or damage valves, sleeves, etc.
@ 4-2 sequence valve and relay valve are located far back in Parallel pin upper body. If they are hard to remove, carefully push them out using stiff wire. @ Be careful not to scratch sliding surface of valve with wire.
Stiff wire
AT-127
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.