Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 30 (Cont’d)

INSPECTION START

wrMONITOR xNO FAIL [|] CAS-RPM(REF) 2087rpm Vv

M/R F/C MNT

LEAN

CHECK EXHAUST GAS SENSOR

[|0.K.,

INSPECTION END

CIRCUIT. 1) Start engine and warm it up sufficiently. 2) Make sure that ‘“‘M/R L RECO } F/C MNT” in “DATA

MONITOR” mode indi-

RD SEF996K cates ‘‘RICH’”’ and “LEAN’”’ periodically more than 5 times dur- ing 10 seconds at 2,000 rpm. OR (=, 1) Start engine and warm (i

it up sufficiently.

2) Run engine at about 2,000 rpm for about 2 _ Check engine light ;

RED LED.

9 9 minutes under no load. 3) Set E.C.U. diagnosis SEF621K mode to Mode I. 4) Keep engine speed at BI

2,000 rpm and make DY. €:) fe OISCONNECT y” €:> RED DISCONNECT on E.C.U. and check

sure that RED L.E.D.

[curt [ol connecror || ©

engine light on instru-

19 | ment panel go on and off more than 5 times during 10 seconds. [a] «i BI ne os ee seroaz|| | CHECK INPUT SIGNAL CIRCUIT. N.G. Repair harness or connectors. Vv 1) Turn ignition switch ‘OFF’. 2) Disconnect exhaust gas sen- sor harness connector and E.C.U. harness connector. 3) Check harness continuity be- tween terminal @ and E.C.U. terminal 49. Continuity should exist. O.K. Vv Replace exhaust gas sensor.

EF & EC-127

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.