SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 1
SYMPTOM: No warning lamp comes on when ignition switch is turned “ON’’. O START ~~ NO
CHECK WARNING LAMP POWER SUP-_
[N.G. || Check and repair wiring.
Cc PLY. SsTise
1) Turn ignition switch ‘‘ON”’.
2) Measure voltage across warning M/T model A/T model ; lamp connector terminal @0) and bry Ge ground. 20 ‘ram HS. Voltage: ; Approximately 12V Lw OL O.K. aN $ Vv (Gh) |
Replace warning lamp.
: SST730B
Diagnostic Procedure 2
SYMPTOM (A):
Warning lamp comes on during operation. START
v Check in self-diagnosis mode. Refer to page ST-48.
Vv Repair malfunctioning part detected by | O-K. END Vv self-diagnosis. [fh sevect pia move [J] Refer to Diagnostic Procedures 5 to 11.
[ SELF DIAG RESULTS
N.G.
J [ active TEST | v
[ DATA MONITOR
[ ECU PART NUMBER
Check connectors for improper contact. | O-K. END Vv N.G. | . y Check steering neutral position. SST724B Refer to page ST-39.
ST-51
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.