Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 45 (Cont'd)

Neutral switch

@ NEUTRAL SW CIRCUIT

,

INSPECTION START

SHIFT out of N/P-RANGE Vv

O.K. THEN

CHECK OVERALL FUNCTION.

INSPECTION END

= 1) Turn ignition switch ‘‘ON”.

TOUCH START

2) Perform “NEUTRAL SW CIRCUIT” in “FUNCTION I START | TEST” mode with CONSULT. SEF206L OR 1) Turn ignition switch “ON”. =

¢¢MONITOR #NO FAIL

[_] 2) Check neutral switch signal in

mode with

DATA MONITOR”

OFF CONSULT. ON

START SIGNAL

IDLE POSITION

Neutral position: ON OFF

AIR COND SIG

Except above: OFF

ON OR (=p \ 1) Set shift lever to the neutral Oe) position.

NEUTRAL SW

2) Disconnect E.C.U. harness con-

RECORD | | nector. SEF384J 3) Check harness continuity between E.C.U. terminal @)

and body ground.

—— ‘4 —

Continuity should exist.

HS &> 35 N.G. Vv Turn ignition switch ““OFF’’.

= C/UNIT_|O| CONNECTOR a)

(ta 1B) v

N.G. Ur} Repair harness or con- 1) Disconnect neutral switch harness nectors. = SEFO011J connector. (3) 2) Check harness continuity between terminal @) and body ground. Continuity should exist. O.K. ‘ y Disconnect E.C.U. harness con- —o Gn nector.

CHECK GROUND CIRCUIT.

N.G. SEF219K:

CHECK INPUT SIGNAL CIRCUIT.

> Check the following. e Harness connectcrs(#9), 1) Check harness continuity between — E.C.U. terminal 8) and terminal @. 4€ €) e Harness connectors Continuity should exist. @), IL

C/UNIT “{e[_connECTOR ]|

Cal) O.K. e@ Harness continuity 35 between E.C.U. and neutral switch lf N.G., repair harness or (oF connectors.

SEF220K EF & EC-155

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.