Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 4 — Hard to Start or

Impossible to Start when the Engine is Cold

N.G.

CHECK BATTERY AND STARTER.

Repair or replace. Vv Check battery and starter condition. (Refer to EL section.) O.K. ¥ No

CHECK FUEL PRESSURE.

Check fuel pump and cir- 4 SEF3801'

1. Pinch fuel feed hose with fingers. cuit. (See page EF & EC-

2. When cranking the engine, is there 152.) ; any pressure on the fuel feed hose? ZN ON Yes v

Fuel filter

( No

CHECK AIR REGULATOR.

Check air regulator and Vv When pinching the air regulator hose, circuit. ON does the engine speed drop? Yes 4 | Vv Yes

CHECK A.A.C. VALVE.

> Check A.A.C. valve and SEF740K When pressing accelerator pedal fully, circuit. (See page EF & can you Start the engine. EC-162.) \" regulator No Vv No

CHECK INJECTOR.

Check injector(s) and cir- =) : Vv

1. Remove crank angle sensor from cuit(s). engine. (Crank angle sensor harness Sy connector should remain connected.) — a

2. Disconnect ignition coil harness con- nector. Pinching

3. Turn ignition switch ON. (Do not start SEF963K engine.)

4. When rotating crank angle sensor shaft, does each injector make an operating sound? fJ ZF ' | Yes

(Go to @ on next page.)

TMen y

SEF 1441

SEF837K

EF & EC-64

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.