Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont'd)

CONNECTING ROD BEND AND TORSION

Bend: Limit 0.15 mm (0.0059 in) per 100 mm (3.94 in) length Torsion: Limit 0.30 mm (0.0118 in) per 100 mm (3.94 in) length If it exceeds the limit, replace connecting rod assembly.

SEM150B

CYLINDER BLOCK DISTORTION AND WEAR

1. Clean upper face of cylinder block and measure the distor- tion. fo] Limit:

0.10 mm (0.0039 in) Cha

2. If out of specification, resurface it. The resurfacing limit is determined by cylinder head resur- Distortion: facing in engine. Less than 0.10 mm (0.0039 in) Amount of cylinder head resurfacing is “A” Amount of cylinder block resurfacing is “B”’ The maximum limit is as follows: A + B = 0.2 mm (0.008 in) Nominal cylinder block height from crankshaft center: 246.95 - 247.05 mm (9.7224 - 9.7264 in)

3. If necessary, replace cylinder block.

SEM255C

PISTON-TO-BORE CLEARANCE

_~—N

1. Using a bore gauge, measure cylinder bore for wear, OOoNn ON: out-of-round and taper. on7 —— © \ (_-- mx Standard inner diameter: ' ,ror (]

89.000 - 89.030 mm (3.5039 - 3.5051 in) ' ' ‘ Wear limit: A r

0.2 mm (0.008 in) Out-of-round (X — Y) limit: XY

0.015 mm (0.0006 in) B Taper (A — B) limit: Unit: mm (in) SEMo40

0.01 mm (0.0004 in) If it exceeds the limit, rebore all cylinders. Replace cylinder block if necessary.

2. Check for scratches and seizure. If seizure is found, hone it.

EM-37

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.