TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 15 — Engine Stalls when Accelerating or when Driving at
Constant Speed (Cont’d)
4]
M@ FUEL PRES RELEASE
i
FUEL PUMP WILL STOP BY
4 | Check fuel pump, circuit
N.G.
CHECK FUEL PRESSURE.
TOUCHING START IN IDLING.
and fuel pressure regula-
1. Perform “FUEL PRESSURE
cn tor. RELEASE” in ‘‘WORK , SUPPORT” mode in order to release fuel pressure to zero. i gens
CRGINE STALL TIMES AFTER
2. Install fuel P pressure gauge START | and check fuel pressure. A few seconds after ignition
switch is turned OFF to ON:
y Approx. 294 kPa (3.0 kg/cm’, 43 psi) At idle: Approx. 235 kPa (2.4 kg/cm”, 34 psi) a w sy, 1. Release fuel pressure to zero.
(Refer to page EF & EC-191.)
(i C=—TM 2. Install fuel pressure gauge and check fuel pressure. SEF3791 O.K. \ 5a Yes || Discover air leak location
CHECK FOR INTAKE AIR LEAK.
Blow-by and repair. When pinching blow-by hose (lowering hose
the blow-by air supply), does the en-
iS gine speed rise? p No ¥ 6 NN |N.G. || Repair or replace.
CHECK E.C.U. HARNESS CONNECTOR.
Check the E.C.U. pin terminals for dam- SEF300G] | age or poor connection of E.C.U. har- ness connector. O.K. v Repair or replace.
Yes »|
CHECK E.C.U. POWER SUPPLY AND
GROUND CIRCUIT.
Refer to page EF & EC-96. No 8 | Vv
TRY A KNOWN GOOD E.C.U."*
’
INSPECTION END
*: E.C.U. may be the cause of a problem, but this is rarely the case.
EF & EC-86
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.