SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS
SUPER HICAS
Rear Axle Housing Ball Joint
CS Turning torque
INSPECTION Swing force ai Measure swing force, turning torque and vertical end play in e axial direction.
Vertical 4
If ball joint is worn, play in axial di rection is excessive, or joint Axle e housing end play is hard to swing, replace ball joint.
| Swina f wing toree | 6.9 - 68.6 N (0.7 - 7.0 kg, 1.5 - 15.4 Ib) | |
|---|---|---|
| wing toree | (0.7 - 7.0 kg, 1.5 - 15.4 Ib) | |
| Ball joint specifi- | 03-29Nm | |
| cations | Turning torque | (3 - 30 kg-cm, 2.6 - 26.0 in-Ib) |
| Vertical end play | 0 mm (0 in) |
SRA349A
REMOVAL Front @ Remove ball joint snap ring. @ Press out ball joint from axle housing.
Ball joint
Axle housing SRA261A ASSEMBLY @ Press new ball joint assembly into axle housing. y LLL H fa YY @ Install snap ring into groove of ball joint. @ Refer to REAR AXLE — Wheel Hub and Axle Housing for other y H Ball joint Yo procedures. Axle housing @ Refer to ST section for power cylinder and SUPER HICAS — Trouble Diagnoses. Front
SRA262A
RA-24
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.