Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Disassembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Disassembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDisassembly (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Disassembly (Cont'd)

POWER STEERING GEAR AND LINKAGE (Model PR24SC)

Disassembly (Cont'd)

11. Remove center bushing and rack oil seal using tape wrap- ped socket and extension bar. Rack oil seal Do not scratch inner surfaces of pinion housing.

Center bushing, |

=| ram Extension bar 29 mm voce

SST472A Inspection Thoroughly clean all parts in cleaning solvent or automatic transmission fluid ‘“DexronTM’ type, and blow dry with com- pressed air, if available. BOOT Check condition of boot. If cracked excessively, replace it. RACK Thoroughly examine rack gear. If damaged, cracked or worn, replace it.

PINION ASSEMBLY

@ Thoroughly examine pinion gear. If pinion gear is damaged, cracked or worn, replace it. @ Inspect bearings to see that they roll freely and are free from cracked, pitted, or worn balls, rollers and races. Replace if necessary.

GEAR HOUSING CYLINDER

Check gear housing cylinder bore for scratches or other damage. Replace if necessary.

CYLINDER TUBES

Check cylinder tubes for scratches or other damage. Replace if necessary.

TIE-ROD OUTER AND INNER SOCKET

@ Check ball joint for swinging force. Tie-rod outer ball joint:

8.8 - 91.2 N (0.9 - 9.3 kg, 2.0 - 20.5 Ib) Tie-rod inner ball joint: e a =

7.8 - 122.6 N (2.36) AS (0.8 - 12.5 kg, 1.8 - 27.6 Ib) 60

Unit: mm (in) *: Measuring points SST750A

ST-16

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.