REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Low & Reverse Brake (Cont'd)
Install return springs, spring retainer and low one-way clutch
4. inner race onto transmission case.
SAT881A
Install dish plate, low and reverse brake drive plates, driven
5. Driven plate plates and retaining plate. \ Install snap ring on transmission case.
6.
—_ |: \ —Y\ a
Dish plate
| \ Drive plate SATB50B
7. Check operation of low and reverse brake clutch piston. Refer to “DISASSEMBLY”.
Measure clearance between retaining plate and snap ring.
8. Vii 4a
If not within allowable limit, select proper retaining plate.
Feeler gauge Specified clearance: Standard
0.7 - 1.1 mm (0.028 - 0.043 in) . Allowable limit
2.3 mm (0.091 in) Retaining plate: Refer to S.D.S.
9. Install low one-way clutch inner race seal ring. @ Apply petroleum jelly to seal ring. @ Make sure seal rings are pressed firmly into place and held by petroleum jelly.
;
Seal "ng HE on ~ L.-
\ ( pie PVAV ET | i .-- SAT8B4A | AT-146
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.