CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont'd)
CAMSHAFT RUNOUT
1. Measure camshaft runout at the center journal. Runout (Total indicator reading): Standard: Less than 0.02 mm (0.0008 in) Limit:
0.04 mm (0.0016 in)
2. If it exceeds the limit, replace camshaft.
SEM926C
CAMSHAFT CAM HEIGHT
1. Measure camshaft cam height. Standard cam height: Intake
42.415 - 42.605 mm (1.6699 - 1.6774 in) Exhaust
42.415 - 43.005 mm (1.6699 - 1.6931 in) Cam wear limit: Intake & Exhaust
0.2 mm (0.008 in)
2. If wear is beyond the limit, replace camshaft.
CAMSHAFT JOURNAL CLEARANCE
1. Install camshaft bracket and tighten bolts to the specified torque.
2. Measure inner diameter of camshaft bearing. Standard inner diameter:
28.000 - 28.025 mm (1.1024 - 1.1033 in)
SEM295D
3. Measure outer diameter of camshaft journal. Standard outer diameter: #1 journal
27.935 - 27.955 mm (1.0998 - 1.1006 in) #2 to #5 journals
23.935 - 23.955 mm (0.9423 - 0.9431 in)
4. If clearance exceeds the limit, replace camshaft and/or cyl- inder head. Camshaft journal clearance: Standard
0.045 - 0.090 mm (0.0018 - 0.0035 in) Limit
0.15 mm (0.0059 in)
CAMSHAFT END PLAY
1. Install camshaft and thermostat housing in cylinder head.
2. Measure camshaft end play. Camshaft end play: Standard
0.070 - 0.148 mm (0.0028 - 0.0058 in) Limit
0.20 mm (0.0079 in)
SEM296D EM-24
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.