PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › PRECAUTIONS AND PREPARATION - Nissan 240SX 1991-1992 Workshop Manual
PRECAUTIONS AND PREPARATION
PRECAUTIONS AND PREPARATION
Precautions @ When installing rubber parts, final tightening must be carried out under unladen condition* with tires on ground. * Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. @ Use Tool when removing or installing brake tubes. @ When removing each suspension part, check wheel alignment and adjust if necessary. @ Do not jack up at the lower arm. SBRS500 Preparation
SPECIAL SERVICE TOOLS
Tool number (Kent-Moore No.) Description Tool name HT71780000 Removing and installing coil spring ( - ) Spring compressor
Fixing strut assembly $T35652000 ( - ) Strut attachment
Removing and installing brake piping GG94310000 ( —- ) Flare nut torque wrench
Removing inner race of wheel bearing
$T30031000 (J22912-01) Bearing puller
Removing and installing bushing $T38280000 of rear axle housing ( —- ) Arm bushing remover
RA-2
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.