Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

ADJUSTMENT (Model R200)

ADJUSTMENT (Model R200)

Pinion Gear Height and Pinion Bearing Preload

(Cont'd) @ Front pinion bearing — make sure the J-34309-3 front pinion bearing seat is secured tightly against the J-34309-2 pilot, turn the front pinion bearing gauge anvil. Then J-34309-5, to secure the bearing in its proper position. — the rear pinion bearing pilot, Rear pinion bearing e@ J-34309-8, is used to center the rear pinion bearing only. The rear pinion bearing locking seat, J-34309-4, is used to lock the bearing to the assembly.

3. Place the pinion preload shim selector Tool, J-34309-1, gauge screw assembly with the pinion rear bearing inner cone installed into the final drive housing.

4. Assemble the front pinion bearing inner cone and the J-34309-2 gauge anvil together with the J-34309-1 gauge screw in the final drive housing. Make sure that the pinion height gauge plate, J-34309-16, will turn a full 360 degrees, and tig hten the two sections together by hand.

5. Turn the assembly several times to seat the bearings.

sPD770

6. Measure the turning torque at the end of the J-34309-2 gauge anvil using torque wrench J-25765A. Turning torque specification:

1.0 - 1.3 Nem (10 - 13 kg-cm, 8.7 - 11.3 in-Ib)

PD-20

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.