Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

COMPRESSION PRESSURE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › COMPRESSION PRESSURE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCOMPRESSION PRESSURE - Nissan 240SX 1991-1992 Workshop Manual

COMPRESSION PRESSURE

COMPRESSION PRESSURE

Measurement of Compression Pressure

Warm up engine. Turn ignition switch off. Release fuel pressure. Refer to ‘‘Releasing Fuel Pressure”’ in section EF & EC. Fuel pump fuse (10A) Remove all spark plugs. Disconnect distributor center cable.

SEF743K Attach a compression tester to No. 1 cylinder. Depress accelerator pedal fully to keep throttle valve wide “© open. Crank engine and record highest gauge indication. 00 (© Repeat the measurement on each cylinder as shown above. Always use a fully-charged battery to obtain specified engine revolution.

Compression pressure: kPa (kg/cm?, psi)/rpm

Standard 1,236 (12.6, 179)/300 Minimum 1,040 (10.6, 151)/300 Difference limit between cylinders 98 (1.0, 14)/300

10. If cylinder compression in one or more cylinders is low, pour a small amount of engine oil into cylinders through spark plug holes and retest compression. If adding oil helps compression, piston rings may be worn or damaged. If so, replace piston rings after checking piston. If pressure stays low, a valve may be sticking or seating improperly. Inspect and repair valve and valve seat. (Refer to S.D.S.) If valve or valve seat is damaged excessively, replace them. If compression in any two adjacent cylinders is low and if adding oil does not help compression, there is leakage past the gasket surface. If so, replace cylinder head gasket.

EM-8

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.