CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont’d)
2. Drive out valve guide with a press [under a 20 kN (2 t, 2.2 US ton, 2.0 Imp ton) pressure] or hammer and suitable tool.
SEM299D
3. Ream cylinder head valve guide hole. - Suitable reamer Valve guide hole diameter (for service parts): Intake —
11.175 - 11.196 mm (0.4400 - 0.4408 in) Exhaust
12.175 - 12.196 mm (0.4793 - 0.4802 in)
SEM300D
4. Heat cylinder head to 120 to 140°C (230 to 266°F) and press service valve guide onto cylinder head. Projection “L”’:
13.3 - 13.9 mm (0.524 - 0.547 in)
SEM301D
5. Ream valve guide. | Suitable reamer Finished size: Intake & Exhaust
7.000 - 7.018 mm (0.2756 - 0.2763 in)
SEM300D
VALVE SEATS
Check valve seats for any evidence of pitting at valve contact surface, and reset or replace if it has worn out excessively. e Before repairing valve seats, check valve and valve guide for wear. If they have worn, replace them. Then correct valve seat. e Cut with both hands to uniform the cutting surface.
SEM302D EM-26
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.